Description
SubliSlate Sublimation Instructions
Instruction Details
Temperature: 400
Time: 7 minutes
Pressure: Medium
Prepress:
Additional: Heat Tape
Paper: TEXPRINT DT (Ricoh AND Virtuoso Printers) OR TEXPRINT DT LT (Epson Printers)
Product ID: SUSL873
Instructions
1. Cover the bottom TABLE of the press WITH a sheet of protective paper.
2. Wrap your transfer around your slate AND tape it TO the back of the slate USING heat tape.
3. Place substrate face up, WITH attached transfer face down, ON top of protective paper, ON bottom table.
4. Cover it WITH a piece of protective paper AND 1/8″ Heat Conductive Green Rubber Pad and press according to time, temperature, and pressure above.Application notes: If you do not use a green pad, your transfer paper may stick to the Slate and it is difficult to remove. Once your green pad heats up, you might want to reduce press time by about 30 seconds. Cleaning the slate before pressing is recommended.
Laser Cutting:
35 watt laser at 70% power and 100% speed at 500ppi
Stack Order for Heat Press
HEAT PRESS PLATEN
GREEN PAD
PROTECTIVE PAPER
TRANSFER
SUBSTRATE
PROTECTIVE PAPER
BOTTOM TABLE
Heat Press Pressure Cheat Sheet
Level
PSI
Press Dial Level
Average Human
Resistance Felt
Contact Pressure
10-15 psi
1 on press dial
Where the platen
just makes physical
contact with product
Light Pressure
20 psi
2 on press dial
Resistant with one
arm pressing down,
easy with two arms
Medium Pressure
40-60 psi
3-5 on press dial
Resistant with two
arms pressing down,
doesn't require usage
of shoulders
Heavy Pressure
80 psi
6 and up on dial
Very resistant with
two arms pressing
down, requires lifting of
elbows and shoulders
to lock in place
Reviews
There are no reviews yet.