Sublimation Enamel Camp Mug – 12oz – White with Silver Rim

Temperature: 400

Time: 4 Minutes Press/8 Minutes Oven

Pressure: Medium

Additional: Heat Tape

Paper: DYETRANS SPP (All printers) TEXPRINT DT (Ricoh/Sawgrass Printers) TEXPRINT Light (Epson Printers)

Product ID: CM11

Instructions

In a Mug Press:
Print the transfer. Note that the typical imaging area is 1.25" in
FROM the handle AND .25" from the top and bottom sides of the cup.1. Tape the image to the camp cup.
2. Wrap in protective paper.
3. Insert in mug press and press at 375° for 4 minutes with medium pressure.
4. Remove transfer asap and use a fan to cool the cup or the A6000 Kool Plate.

Oven Method Instructions

In an Oven Using DYEWRAP05

Temp at 365°
Tighten the wrap as much as you can to get a snug fit. This video shows how to do this:
DyeWrap Overview Video

1) Print the transfer. Note that the typical imaging area is 1.25" in
FROM the handle AND .25" from the top and bottom sides of the cup.

2) Trim the transfer closely. If you are going to use heat tape to attach the transfer make sure to leave some unimaged paper on the edges closest to handle to attach the tape.

3) Lightly mist transfer with Pro Spray and let dry 15-20 seconds. Carefully place the transfer on the cup, tucked under the lip, smooth wrinkles.

Note: If you have poor image edges - one idea is to slightly dampen the back of the image transfer - position it and wipe with slightly damp cloth.

Or

Place heat tape on the transfer edges closest to the handle that does not have sublimation ink on it after you have aligned the image on the cup. Use heat tape to attach the transfer to the cup taking care not to cover any of the imaging area

4). Wrap the cup with protective plain white paper. Trim closely.

5. - 8 minutes
Press with Temp/Time/Pressure settings listed above.

6) Use a fan to cool the cup or the A6000 Kool Plate.

7) Remove any paper residue with a soft wet cloth or dish sponge.

Note: This mug is not recommended to be used for heating or cooking.

Shrink Instructions

Instructions for Using an Oven and Sublimation Shrink Wrap

375 6 Minutes

1. Preheat oven to 375°
2. Cut out template and tape it tightly to your mug
*Optional- if adding a handle design make sure that it is taped down securely.
3. Cut a slit about 2 inches from the bottom of the shrink wrap (SF79) and slip the wrap over the mug with the handle out
4. Tape shrink wrap under handle to ensure that it will not separate when tightened with heat
5. Tuck excess SubliShink into the mug and evenly tighten the wrap by using the heat gun to apply hot air
6. Place in preheated oven for 6 minutes
7. Use caution to remove Sublimation Shrink Wrap and paper from hot mug immediately
8. Allow mug to cool under a fan or using a Kool Plate